|
Problem:
| | Figure 14.8 (on page 156) shows a 1K resistor but the parts list (on page 154) and the circuit diagram (on page 155) show it as a 10K resistor.
| |
|
Solution:
| | The actual value of the two fixed resistors on the PIC board do not matter. Either 1K or 10K can be used for either or both. There will be a slightly higher current drain if a 1K is used for R2 and the switch is closed so I would recommend using 10K resistors for both R1 and R2.
| |
|
Further information:
| | I hope that this page helps you with your projects but if you have found any other problems or if you have any further questions please contact me though the email address of gares-AT-g4aym-DOT-org-DOT-uk.
Sorry about the email address but it seems to be the only way to avoid the spammers
|
|